Phone Info and Mount location (Lat/Long) are the same values (when the values are shown in the Telescope Setting screen). When I press this button (Sync to Mount), I get a small icon that shows Sync Failure, then disappears. The Phone Info also shows the correct Lat/Long information, but the Sync To Mount (green button) doesn't work. RA & DEC information is correctly displayed, including the correct time.
Checked the Hand Controller information and the Lat/Long was shown to be correct (Menu>View Time-Site). However, last night, while testing the setup, unexpectedly found the Mount information was populated with the incorrect Longitude information (showed E 266 11 03 when the correct value is 93 48 45) and the Lat information was correct. After closing the application as described above, able to slew and control the scope on the main application screen. I then restart the application, and the Telescope Setting screen is now populated (displaying) with the Mount Information. I was able to fix this issue by exiting the application (e.g., display the missing Mount information), closing the application on the iPad (double click home, then flick the application off the open application screen to close the application). When I select (turn On) the Telescope, can see the little spinning icon, icon then stops & disappears, but nothing appears or is displayed (Mount information) on the Telescope Setting screen. However, when selecting the Telescope Setting (e.g., selecting Celestron AVX/CGE/CGEM/CGX mount) with Serial (USB-RS232) and Baud rate of 9600, and the on/off button is set to ON (and the GoTo Auto-Center & Tracking are turned off), there's no displayed Mount information. Have not had any good weather to fully test (e.g., plate solve, guide and image) using the ASIair with this setup but have been able to "align the mount/scope" to test the setup and connections.Īfter connecting to the ASIair, I can easily see the cameras, EFW and EAF device information. Using ZWO 1600MC or 071MC (Main imaging) & 120MM (guide) camerasĬonnecting via 5G (through a Netgear Extender), and can connect directly to ASIair too Handcontroller is up-to-date with GEM with MC Good morning - here's my setup (see below).įinding erroneous values associated with Lat/Long in ASIair when selecting Celestron AVX as the Telescope Setting.Ĭelestron AVX (USB to mini connection) with GPS (successfully acquiring lat/long/time from the unit)
0 kommentar(er)
